|
|
Регистрация | Пригласить друга | Все альбомы | Файловый архив | Справка | Сообщество | Календарь | Сообщения за день | Поиск |
|
Опции темы |
19.12.2011, 07:56 | #1 |
Новичок
Регистрация: 25.05.2011
Адрес: Новосибирск
Сообщений: 10
Репутация: 0
|
Bizhub 203 ошибка С-4553
с датчиком вроде все нормально. после закрытия крышки он начинает проверку, далее издается треск и опять выпадает в эту ошибку... |
19.12.2011, 10:12 | #2 |
Местный
Регистрация: 17.09.2009
Адрес: Россия
Сообщений: 1,246
Репутация: 20
|
поиск рулит.
http://forum.trade-print.ru/konica-m...253-c4553.html Konica minolta bizhub c203 error c4553 Problems My Konica Minolta Bizhub C353 is showing a C-4553 - FixYa C-4553 - FixYa Solutions (1) This is a Yellow Laser Unit Error. SOS signal is not detected even after thelapse of a given period of time after starting the laser output. This is a Rank B error. To clear a Rank B error you open and close the front door and/or do a trouble reset: 1. Turn OFF the main power switch.2. Turn main power switch ON while pressing the Utility/Counter key.3. Touch [Trouble Reset].4. Check to make sure that [OK] is displayed and the it has been reset.5. After turning off the main power switch, turn it on again more than 10 seconds after and check if the machine starts correctly. Please note: I believe there was a factory bulletin out on this model and Konica Minolta furnished new laser units free of charge. I think that program is over however. These lasers had a high rate of failure due to a design or manufacturing problem If this is the case ALL Laser Units need to be changed at the same time. The lot numbers must be entered in the service mode for alignment and calibration purposes. |
|
"Форум индустрии цифровой печати" 2008-2023 Все вопросы по сотрудничеству: Электропочта: info@trade-print.ru Москва, Печатников пер. |