Minolta Di620 "add toner"

[Аксенов Александр]

Закончилась туба, вставил новую, пишет "add toner".
Мотор хопера не крутит, разобрал все прочистил.
Тонер в developing unit засыпал.
Датчик тонера в суб хопере фунциклирует.
ATDC sensor чистый.
Напряжение ATDC sensor снижал до минимума.
ATDC sensor переколибровал.

Все описаное ниже делал:

when you put directly toner (3 toner tea spoon in dv unit) have you always message "add toner". no... replace motor (turn bottle)

If that doesnt work when you get in the tech rep mode i would check the ATDC level against what is registered in the adjustment mode, if they are too far off I have had a similar issue. Adjust the ATDC levels in the adjustment screen need to be within reason to the level in the tech rep mode. When you adjust i would only move a 1/2 voltage at a time.

Make sure your toner motors are good and the surface of the ATDC sensor is clean before you adjust the levels in adjustment mode

Make sure the back is screwed on properly. There is a sensor on the bottom left that if it is not blocked will cause a false "add toner" message
Hope this helps
Darren

SOLUTION
1. check the ATDC value go to the service mode utility>meter>stop-0-0-stop-0-1
2. press stop then start
3. click the printer in the control panel
4. chose the ATDC CONTROL level
5. check the value if the value is 6.0 make it 5.0 or 4.0 or if the value is higher make it in the lower
6. then press reset make test copy

Остлось только мозги вправить:

I personally really like the di 470. we have lots of them. clean the atdc sensor. and then the aidc sensor. if I was on this call I would personally look at the toner motor. even though you would think that the copies are great so the atdc sensor must be telling the machine that the toner to carrier ratio is low. then it should add toner. basically your copies should be a little faded then it should ask for toner. then the toner bottle does not spin..thus the machine will say.. add toner. I have an attatchment that I just found on km.com I have never had to do this. but it might be a good thing. take a look
add toner..pdf

Поделитесь прошивкой на Di620 у кого есть возможность.

[Александр Аксенов]

abc, крышка задняя, залез не совсем зря, девелопера грамм 150-200 осталось, так что ждал сюрприз, через пару месяцев. Да и по логике я так и не понял каким боком датчик на задней крышки относится к тонеру, логичнее ковырять хопер, сабхопер и дев юнит.
Подскажи, насколько девелопер совместим среди минолт, например тонер от 35х/45х подсыпает, от бизхабов фонит, но настройками не игрался, тонер впринципе есть по 500р за кг, а вот девелопер ждать долго родной.