Bizhub 203 ошибка С-4553

[=John=]

Добрый день, подскажите что за ошибка С 4553 и как от нее избавиться. По факту он просит открыть и закрыть переднюю крышку, но после этого ничего не меняется.
с датчиком вроде все нормально. после закрытия крышки он начинает проверку, далее издается треск и опять выпадает в эту ошибку...

[polyprint]

поиск рулит.
http://forum.trade-print.ru/konica-m...253-c4553.html
Konica minolta bizhub c203 error c4553 Problems
My Konica Minolta Bizhub C353 is showing a C-4553 - FixYa
C-4553 - FixYa

Solutions (1)
This is a Yellow Laser Unit Error. SOS signal is not detected even after thelapse of a given period of time after starting the laser output. This is a Rank B error. To clear a Rank B error you open and close the front door and/or do a trouble reset:
1. Turn OFF the main power switch.2. Turn main power switch ON while pressing the Utility/Counter key.3. Touch [Trouble Reset].4. Check to make sure that [OK] is displayed and the it has been reset.5. After turning off the main power switch, turn it on again more than 10 seconds after and check if the machine starts correctly.
Please note: I believe there was a factory bulletin out on this model and Konica Minolta furnished new laser units free of charge. I think that program is over however. These lasers had a high rate of failure due to a design or manufacturing problem

If this is the case ALL Laser Units need to be changed at the same time. The lot numbers must be entered in the service mode for alignment and calibration purposes.