|
|
Регистрация | Пригласить друга | Все альбомы | Файловый архив | Справка | Сообщество | Календарь | Сообщения за день | Поиск |
|
Опции темы |
29.11.2021, 12:40 | #1 |
Новичок
Регистрация: 14.01.2020
Адрес: Ашхабад
Сообщений: 16
Репутация: 0
|
Xerox versant 2100 078-126 что делать помогите
|
29.11.2021, 13:02 | #2 |
Местный
Регистрация: 22.09.2008
Адрес: РФ
Сообщений: 589
Репутация: 81
|
Re: Xerox versant 2100 078-126 что делать помогите
может для начала позвонить в сервис ксерокса ?
|
29.11.2021, 13:16 | #3 |
Местный
Регистрация: 25.04.2016
Адрес: BY
Сообщений: 258
Репутация: 12
|
Re: Xerox versant 2100 078-126 что делать помогите
Fault Codes 078-125, 078-126, 078-127 or 078-215 occur when the Printer has detected that multiple sheets of paper have been fed into Trays 5, 6 or 7 in the Oversize High Capacity Feeder module.
The following are the top reasons why paper jams occur: unsupported paper/media is used. incorrect paper settings in the tray and/or the print driver. paper loaded incorrectly and/or paper edge guides not adjusted properly in the tray. humidity and/or paper condition and storage. Use a new ream of paper. Fan the paper and turn over. To resolve the issue, perform the following: Clear Paper Jams Inside Trays 6 and 7. Also clear Paper Jams in the Bypass (Tray 5) When the Bypass is Installed on Trays 6 and 7. Clean the OHCF Feed Rolls. Power Off and On the Oversize High Capacity Feeder. Power Off the Press, Wait 5 Minutes, and Then Power On the Press. Replace the Feed Rolls in the Tray. If the problem persists, contact Support for additional assistance. |
29.11.2021, 13:49 | #4 |
Пользователь
Регистрация: 27.02.2020
Адрес: Архангельск
Сообщений: 59
Репутация: 1
|
Re: Xerox versant 2100 078-126 что делать помогите
У Вас либо мульти захват с лотков (не по 1 листу)
Либо помер датчик мультиподачи, если идёт по 1 листу |
|
"Форум индустрии цифровой печати" 2008-2023 Все вопросы по сотрудничеству: Электропочта: info@trade-print.ru Москва, Печатников пер. |