ошибка с-0203

[Кирилл полиграфия винстон]

как обнулить ошибку или какой то датчик надо менять?написано ошибка лотка 3

[Vladimir24]

дипсвич 18-2 = 1 - отключение 3 лотка
датчик PS42
Может быть не датчик, а мотор.

[Chernov]

может кому полезно будет

Code
C-0203
Classification
Main body: Paper feed tray abnormality
Cause
The upper limit sensor /3 (PS42) does not turn ON within a specified period of time after the paper lift motor /3 (M40) turns ON.
Measures to take when alert occurs
The main body stops immediately to turn OFF the power relay (RL1).
Estimated abnormal parts
• Printer control board (PRCB)
• Paper lift motor /3 (M40)
• Upper limit sensor /3 (PS42)
• Pick-up solenoid /3 (SD9)
Correction
Turn OFF/ON the sub power switch (SW2) of the main body.
Note
• The message "Please call service" is displayed on the panel.
Solution
1. Check the paper loaded condition and the rear end restriction plate condition of the tray 3, and repair it if any abnormality.
2. Check the connector connection and the wiring between PRCB and motor/sensor, and repair it if any abnormality.
3. Check the I/O drive of the motor and the solenoid and the coupling of the gear, and repair/replace it if any abnormality. (Wiring
diagram: Main body (1/3): 13-E, 21-M)
4. Check I/O and the operation of the sensor, and repair/replace it if any abnormality. (Wiring diagram: Main body (1/3): 20-M)
5. Replace PS42.
6. Replace SD9.
7. Replace M40 and PRCB at a time.
Faulty part isolation DIPSW
DIPSW18-2
Control while detached
Paper feed in tray 3 is unavailable

[Кирилл полиграфия винстон]

и всегда лучше иметь мотор в наличии,у наших официалов под заказ их только привозят ни когда в наличии нету.