16.06.2009, 16:17 | #1 |
Местный
Регистрация: 13.05.2009
Адрес: Ростов-на-Дону
Сообщений: 1,273
Репутация: 274
|
Xerox DC12 ошибка 7-501
Ситуация какая - во время выполения MAX Setup, а точнее TRC Control машинка начинает шуметь-гудеть, но потом на доли секунд высвечивается ошибка 7-501 и все, можно начинать сначала. С третьей-четвертой попытки все ОК. Вот решил озадачится что за ошибка-то такая. Как я понимаю семерка указывает на проблемы с подачей бумаги, но вот что дальше делать пока не пойму... Заранее спасибо за внимание и понимание |
16.06.2009, 17:56 | #2 |
Гость
Сообщений: n/a
|
7-501 Tray No Paper RAP
Description The machine detected no paper in the paper tray selected. NOTE: This RAP should be used when the presence of paper is not detected in any of the Paper Trays or if the paper tray selected ran out of paper and the Auto Tray Selection (ATS) could not find paper of the same orientation from another tray to finish the job. Initial Action Check the following items for dirt, binding, freedom of movement or excessive wear: Tray No Paper Sensor, Tray Level Sensor, and Tray Nudger Solenoid. Verify that the Trays are not jammed. Ensure that all paper sizes are correct. Ensure paper is properly loaded in the Trays. Ensure all paper Trays are closed. |
Опции темы | |
|
"Форум индустрии цифровой печати" 2008-2023 Все вопросы по сотрудничеству: Электропочта: info@trade-print.ru Москва, Печатников пер. |