|
|
Регистрация | Пригласить друга | Все альбомы | Файловый архив | Справка | Сообщество | Календарь | Сообщения за день | Поиск |
|
Опции темы |
23.03.2011, 14:34 | #1 |
Пользователь
Регистрация: 07.04.2010
Адрес: Тюмень
Сообщений: 63
Репутация: 2
|
С 252 совмещение лицевой и оборотной
|
24.03.2011, 00:30 | #2 |
Местный
Регистрация: 10.02.2011
Адрес: Алма-Ата
Сообщений: 2,991
Репутация: 262
|
Для начала настроить регистрацию передней кромки:
Adjustment Specification Width A on the test pattern produced should fall within the following range. Specifications: 4.2 ± 0.5 mm Setting Range: -3.0 mm to +3.0 mm (in 0.2 mm increments) Adjustment Instructions If width A is longer than the specifications, make the setting value smaller than the current one. If width A is shorter than the specifications, make the setting value greater than the current one. Setting/ Procedure 1. Call the Service Mode to the screen. 2. Touch [Machine] → [Printer Area] → [Print Positioning: Leading Edge]. 3. Select the [Plain Paper]. 4. Press the Start key to let the machine produce a test pattern. 5. Check the dimension of width A on the test pattern. 6. If width A falls outside the specified range, change the setting using the [+] / [-] key. 7. Press the Start key to let the machine produce a test pattern. 8. Check the dimension of width A on the test pattern. 9. If width A is outside the specified range, change the setting again and make a check again. 10.If width A falls within the specified range, touch [END]. 11.Following the same procedure, adjust for Thick 1 to 3, OHP Film, and Enve. |
24.03.2011, 07:59 | #3 |
Пользователь
Регистрация: 07.04.2010
Адрес: Тюмень
Сообщений: 63
Репутация: 2
|
Большое спасибо! А то замучался уже. Машинка старенькая (хоть и работает исправно) и сервисники с ней не хотят заморачиваться.
|
|
"Форум индустрии цифровой печати" 2008-2023 Все вопросы по сотрудничеству: Электропочта: info@trade-print.ru Москва, Печатников пер. |