Цитата:
Сообщение от taner
Вот такая веселуха наблюдается на сканах А3 формата.
|
Во вложении выдержка из TSG для С6500 - возможно пригодится.
Настройка второго переноса в PRO C500:
CAUSE: Depending on the paper type or environment, the second transfer current may be insufficient.
SOLUTION: To increase the second transfer current, perform the following:
1. Access the 36 mode. With the reset switch (SW1) left ON, power OFF the main switch (SW2).
2. Turn ON SW2 while pressing the numeric buttons 3 and 6 at the same time.
3. The "36 mode menu screen" is shown. At this point, the machine enters the 36 mode.
4. Select the Process adjustment. For the process adjustment, there are the following items provided:
[1. High voltage adjustment]
[2. Drum peculiarity adjustment]
[3. Sensor output adjustment]
[4. Private paper adjustment]
[5. Return to standard data]
5. Select [1. High voltage adjustment]. For the high voltage adjustment, the following items are selectable:
[1. 1st transfer manual adjustment]
[2. 2nd transfer manual adjustment]
[3. Separation AC manual adjustment]
[4. Separation DC manual adjustment]
[5. Pre-transfer guide plate manual check]
6. Select [2. 2nd transfer manual adjustment].
7. Press the [PREVIOUS SCREEN] key to return from each of the adjustment screens to the "Drum peculiarity adjustment' menu screen.
8. Exit the service screen and restart the engine from the main Power switch concluding the process.