Код C-D252 (CD252) при запуске. Причина: настройка МФУ контроллера не соответствует установленным контроллером.
Description
CD252 (C-D252) code at start up.
Solution
CAUSE: The Controller 1 setting is enabled in Tech. Rep. Mode without the IC-409 (Fiery® controller) installed.
SOLUTION: To reset the error code, perform the following:
1. Press Utility/Counter button.
2. Press ‘Job Details button’ on the operation panel.
3. Press Utility/Counter button.
4. Repeat steps 3 and 4 until ‘Meter Count’ is displayed on the operation panel.
5. Press ‘Check Details’ button.
6. Enter Tech. Rep Mode (Stop, 0, 0, Stop, 0, 1).
7. Press ‘System 2’ button.
8. Press ‘Image Controller’. Button.
9. Press ‘Controller 0’ for the standard controller.
10. Exit Tech Rep Mode.
11. Cycle power OFF/ON.
SPECIAL NOTE : Solution contribution by Tom Kelly, Workgroup/SSD