Цитата:
Сообщение от HFSI
kamerzator, скачайте мануал, почитайте хотя бы бегло:
When the Developer has been replaced, perform this process.
Procedure
1. Enter Service Diagnostics (page 4-9).
2. Scroll down the menu and select Adjustments/ Calibrations. Press the OK
button.
3. Select ATC Sensor Setup and press the OK button.
4. Note the current values for the tag numbers on the Control Panel display. The
values should correspond to the tag numbers of the Developers currently
installed.
5. Select the color of the Developer you replaced.
6. Enter the tag number. Use the Back and Help buttons to select which digit you want to change. Use the Up and Down buttons to modify the digit.
7. Press OK to enter the data in the Engine NVRAM.
8. Press any button to abort the process.
|
до этого читал но забил, хочу уточнить, значения надо записать до замены нового или после замены? сейчас я просто хочу проверить новую проявку а то мало-ли, вообще я ее беру для подстраховки потому как на старой еще можно долго печатать. Вариант держать новую проявку в коробке стремный, вдруг когда она понадобится что-то пойдет не так. Смысл такой: ставлю новую-проверяю-ставлю обратно в коробку и устанавливаю старую.