Цитата:
Сообщение от alex76
Интерфейсная плата есть новая незадорого.
Если порт спалили, чтож теперь делать.
|
сколько?
в в service manual c6900 c9800 есть такая инфа
"Communication Error" is displayed
CU PCB Malfunction
Does the LED lightup normally? (PWRJ300D Green: Light ON, DIAG_LED3-0 Red: Light OFF, FPGA_LED Green: Light ON) -> If NO GOOD, remove in the sequential order of BYN PCB (optional), HMK PCB, RAM_DIMM, and HDD. Does the Light On state vary?
If the LED Light On state is Normal, replace the applicable part. If light ON is not normal, then replace PCB.
у меня PWRJ300D Green: Light светит DIAG_LED3-0 светит
FPGA_LED не светит