Цитата:
Сообщение от Собченко Николай
Может кто нибудь подсказать куда еще рыть?
|
Вот, накопал на просторах Интернета:
1.C-2401 normally indicates a failed erase lamp, although it is caused, in this case, by a bind in the drum carriage.
Remove and inspect the drum carriage assembly. Run the Toner Cartridge Set mode as well as the Developing unit/Drum.
2. Open ICP6 on the PRCB.
Check for broken or shorted wires in Tray 3 area and repair as necessary. Replace the PRCB (p/n 57AA-9020).After replacing the PRCB, go to the Service
Mode and set softswitch 32, bit 1 to"0" (OFF).Then re-flash the firmware and, after restarting the machine, set softswitch 32, bit 1 to "1" (ON).
Вообще-то эта ошибка напрямую не указывает на неисправность кулера или платы, а на возникновение некоего ненормального состояния в определённый момент времени (отсчитанного от включения вентилятора проявки)
Для быстрой диагностики можно перекинуть драм картридж целиком с одной машины на другую.